Top and Bottom Guiding
A well accepted industry standard particularly suited for double seated plugs to provide adequate support against side loads.
High Capacity with Low Recovery
Flow capacity is at top levels for contemporary double seated regulators and is attained with very little pressure recovery as indicated by a high critical flow factor.
Reduced Capacity Trim
0.4 Factor Trim – the most practical double seated trim design giving a substantial reduction in capacity while maintaining desirable flow characteristics.
High Performance Materials
Materials of construction have been selected for high performance and long life when handling the high pressure drop capabilities of the valve.
High Temperature Applications
For temperatures over the rating of the diaphragm material, the regulator must be mounted with the actuator below the centerline of the regulator body. The diaphragm will be protected from the high temperature by a condensate barrier in the sensing line and actuator diaphragm case. If installed otherwise, an adequate condensate barrier must be incorporated. Consult factory for more information.
Models 525 and 526 Regulators are designed for use with the 10900 Series Actuators for reducing, back pressure and differential pressure applications. Refer to Technical Specifications bulletin GEA19537A for actuator selection.
Sizes: ¾” through 4”
(20 through 100 mm)
Ratings and Connections:
• Flanged: ANSI 150 – 600
UNI-DIN 10 -100
• Screwed: NPT
• Welded: BW or SW
• Carbon steel
• Stainless steel
• Model 10900 with springopposed
• Disc plug, double seat
• 0.5 to 330 psi
(0.034 to 22.7 bar)